Connecticut Seal

Substitute Senate Bill No. 331

Public Act No. 03-59

AN ACT EXEMPTING CERTAIN MINOR SHEET METAL WORK FROM LICENSING REQUIREMENTS.

Be it enacted by the Senate and House of Representatives in General Assembly convened:

Section 1. Section 20-340 of the general statutes is repealed and the following is substituted in lieu thereof (Effective October 1, 2003):

The provisions of this chapter shall not apply to: (1) Persons employed by any federal, state or municipal agency; (2) employees of any public service company regulated by the Department of Public Utility Control or of any corporate affiliate of any such company when the work performed by such affiliate is on behalf of a public service company, but in either case only if the work performed is in connection with the rendition of public utility service, including the installation or maintenance of wire for community antenna television service, or is in connection with the installation or maintenance of wire or telephone sets for single-line telephone service located inside the premises of a consumer; (3) employees of any municipal corporation specially chartered by this state; (4) employees of any contractor while such contractor is performing electrical-line or emergency work for any public service company; (5) persons engaged in the installation, maintenance, repair and service of electrical or other appliances of a size customarily used for domestic use where such installation commences at an outlet receptacle or connection previously installed by persons licensed to do the same and maintenance, repair and service is confined to the appliance itself and its internal operation; (6) employees of industrial firms whose main duties concern the maintenance of the electrical work, plumbing and piping work, solar work, heating, piping, cooling work, sheet metal work, elevator installation, repair and maintenance work, automotive glass work or flat glass work of such firm on its own premises or on premises leased by it for its own use; (7) the fabrication of glass products or electrical, plumbing and piping, fire protection sprinkler systems, solar, heating, piping, cooling, sheet metal or elevator installation, repair and maintenance equipment used in the production of goods sold by industrial firms; (8) persons performing work necessary to the manufacture or repair of any apparatus, appliances, fixtures, equipment or devices produced by it for sale or lease; (9) employees of stage and theatrical companies performing the operation, installation and maintenance of electrical equipment if such installation commences at an outlet receptacle or connection previously installed by persons licensed to make such installation; (10) employees of carnivals, circuses or similar transient amusement shows who install electrical work, provided such installation shall be subject to the approval of the State Fire Marshal prior to use as otherwise provided by law and shall comply with applicable municipal ordinances and regulations; (11) persons engaged in the installation, maintenance, repair and service of glass or electrical, plumbing, fire protection sprinkler systems, solar, heating, piping, cooling and sheet metal equipment in and about single-family residences owned and occupied or to be occupied by such persons; provided any such installation, maintenance and repair shall be subject to inspection and approval by the building official of the municipality in which such residence is located and shall conform to the requirements of the State Building Code; (12) persons who install, maintain or repair glass in a motor vehicle owned or leased by such persons; (13) persons or entities holding themselves out to be retail sellers of glass products, but not such persons or entities that also engage in automotive glass work or flat glass work; (14) persons who install preglazed or preassembled windows or doors in residential or commercial buildings; [and] (15) persons registered under chapter 400 who install safety-backed mirror products or repair or replace flat glass in sizes not greater than thirty square feet in residential buildings; and (16) sheet metal work performed in residential buildings consisting of six units or less by new home construction contractors registered pursuant to chapter 399a, by home improvement contractors registered pursuant to chapter 400 or by persons licensed pursuant to chapter 393, when such work is limited to exhaust systems installed for hoods and fans in kitchens and baths, clothes dryer exhaust systems, radon vent systems, fireplaces, fireplace flues, masonry chimneys or prefabricated metal chimneys rated by the Underwriter's Laboratory or installation of stand-alone appliances including wood, pellet or other stand-alone stoves that are installed in residential buildings by such contractors or persons.

Approved June 3, 2003